How do I hard code bitrates / audio source / video resolution?

Follow these quick steps to hard code your BoxCaster for video bitrate, audio bitrate, audio source, video resolution, and DSCP value. 

NOTE: If you hard code your BoxCaster under the account settings page, these selections will be applied to ALL broadcasts going forward. If you want to hard code your BoxCaster for one event, go to the advanced settings in that one event. 

1. Look on the left-hand side of the dashboard and go to Settings. 

2. Click on the tab BoxCaster and then edit. 

settings.jpg

 

3. Click on the Show Advanced Settings button and this will give you a drop-down menu with all the options you can hard code. 

Advanced_Settings_.jpg

NOTE: The box will automatically choose an acceptable bitrate and resolution based on network and camera responses. These settings are only if you want to specifically force your broadcast settings. 

 Below is a more in-depth description of what each area means. 

  • Video Bitrate: The bitrate at which video data will be encoded and transmitted. By default, the BoxCaster will automatically detect your available bandwidth and make an intelligent selection. The video bitrate can be changed at any time during the broadcast if you are experiencing network issues that are affecting video qualityNote that hardcoding a video bitrate will only establish a ceiling for your video bitrates (i.e. the stream will not exceed that bitrate) but the box will still regulate bitrates up and down throughout the course of your broadcast in response to network conditions.

  • Audio Bitrate: The bitrate at which audio data will be encoded and transmitted. By default, the BoxCaster will automatically detect your available bandwidth and make an intelligent selection.  Audio bitrates can be changed at any time during the broadcast (128k is best for Audio).

  • Audio Source: The source the BoxCaster should use for audio data.  You can choose a specific source in the event you are using a separate line from your video.  For example, you can bring your video in via HDMI and your audio from a mixer via RCA (red/white) and simply select Analog Only so that the box will ONLY pull audio from the RCA jacks.

  • Video Resolution: The maximum resolution at which the video data should be encoded. By default, the BoxCaster will use the largest size available based on the resolution of the detected video input.

  • DSCP Value: DSCP, which stands for Differentiated Services Code Point, is a means of marking network communications in order to prioritize some types of traffic over others. By default, the BoxCaster will not use any special DSCP marking. Speak to your network administrator before changing this value. "Default" is the recommended setting.
Have more questions? Submit a request

0 Comments

Article is closed for comments.
Powered by Zendesk